Replace the rubber cover.
Start by pushing the rubber cover in by the antenna and continue
around the edge until the cover is fixed in place.
Make sure not to twist the cover with the antenna.
(The remote control will function over short distances even without the
antenna.)
Picture A
Picture B
Picture C
Picture D
Picture E
6.2 Coding the remote control (transmitter and receiver)
When programming the remote control, both the remote control
(sender) and the receiver in the thruster control unit must be in
programming mode.
Follow the procedure as described below
1. Choose the pair of buttons on the remote control that is to be
programmed
2. Press both buttons simultaneously for approx 12 seconds.
When a small beep can be heard and the green “power” lamp
starts blinking, the remote control is in programming mode. It
will stay in this mode for 5 min, or until it is finished
programmed (Picture A)
3. Push and hold both buttons down on the mounted panel while
turning on the anchor winch main switch. After the buttons are
released, the receiver will be in programming mode for 10
seconds. (Picture B, C and D)
4. Immediately push and hold one of the buttons (of the chosen
pair) on the remote control until a new beep is heard. The
programming of the remote control and the receiver is now
completed.
5. When releasing the button after programming is complete, the
remote control will turn itself off. To turn it on, press one of the
buttons for 1.5 seconds.
6. Turn off the anchor winch main switch for 5 seconds before
turning it on again.
7. Check that the remote control operates correctly. NB!
Remember to always start with pushing the “down”-button
after the main current has been turned off.
NB! As an alternative way to pt. 3, one can do the following:
Disconnect cables on the mounted panel which are connected to 1, 2
and 3 on the green terminal plug on the control unit. Cut two small
wires (5 cm), and strip approx. 10 mm from their ends. Connect these
between 1 and 2, and also 2 and 3 on the green terminal plug
(Picture E). Turn on the current, and proceed with the
coding/programming as described in pt 4 and 5. Disconnect the small
wires and proceed with pt 6 and 7.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais