Engbo XF 60 VR Especificações Página 9

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 11
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 8
IMPORTANT: When installed in boats approved or classified according
to international or special national rules, the installer is responsible for
following the demands in accordance with these regulations /
classification rules. The instructions in this manual cannot be guaranteed
to comply with all different regulations / classification rules. The remote
control is approved for use in EU/EFTA countries (CE) or US/Canada
(FCC). For other countries, please contact your local authorities.
7. Technical specifications – wireless remote control
Wireless remote:
Motor Control Unit:
Model:
RC-01 ECU-01
Power supply:
3 x 1.5 V DC
(3 x AAA/LR03 batteries)
From thruster (integrated)
Battery life:
2–3 years (normal leisure use) Not applicable
Communication:
Two-way, narrowband, GFSK modulation
Operating frequency:
868.075 – 869.125 MHz, CE (EU/EFTA)*
902.175 – 903.025 MHz, FCC (US/Canada)*
Channels:
16 for communication
Channel separation:
50 kHz
Address range:
65.535 (16 bit), spread among the 16 channels
Temperature range:
-20 to +60 degrees Celsius/-4 to +131 degrees Fahrenheit
Relative humidity
(without condensation):
20% – 90%
Weight:
105 g Model dependent
Dimensions (HxWxD):
127x53x22 mm Model dependent
Environment protection:
(Floating)**
IP 68 IP 41
*May apply to other countries. For information, please contact local authorities for the country
concerned.
**Conditional upon correct installation and intact rubber gasket and O-rings.
8. Battery replacement
The remote control uses three regular AAA/LR03 alkaline batteries. The
battery life is more than two seasons under normal leisure use.
When replacing batteries, open the unit by unscrewing all five screws.
NB: The screws are of different lengths and have O-rings under the
screw heads.
Replace the batteries and make sure all point the same way with the +
up and the – downwards towards the edge as illustrated.
Reassemble the back cover and carefully screw the parts together until
the housing gasket is lightly compressed
. The remote will remain
waterproof as long as the O-rings and gasket are intact with correct
compression.
NB: To ensure a long lifetime, this remote control has acid-proof
machine screws and screw inserts in the housing. The screws may
penetrate the housing if screwed carelessly or too much force is used.
(Not covered by the warranty.)
9. Maintenance
Periodically before each season, or minimum once a year, check the electrical connections and
correct function according to the thruster user instructions.
Vista de página 8
1 2 3 4 5 6 7 8 9 10 11

Comentários a estes Manuais

Sem comentários